• Bosaso, puntland , Somalia
  • Bosaso, puntland , Somalia

The Best Techniques for Hanging Wallpaper

Line an area with wallpaper and you’ve got instant decoration. From blah to daring within a matter of hours, newspaper can push boundaries outside what paint can do. It enlivens walls with textures or patterns or both–your pick. And as a bonus, it pushes minor imperfections in plaster and drywall, too.

But as frequently as homeowners attempt to hang themselves, they seldom get it right, cursing their paring tiles and mismatched patterns–it is enough to drive you up a wall. Input John Gregoras, a pro newspaper hanger from Somers, New York, with nearly two decades’ experience. We asked Gregoras to demonstrate a few of his best wallpapering tips and shortcuts for pasting, hanging, aligning, and trimming. And, boydid we learn a great deal – everything from how he plans the design to how he lines up the last seam. With this kind of insider know-how, papering only got a great deal simpler.

Greatest Wallpaper Techniques Overview

Layout is your key when you are learning how to hang wallpaper. Paying attention to the sequence in which the paper goes up guarantees that your pattern will stay well-matched and look straight. John Gregoras recommends functioning in one direction around the space to keep the pattern consistent.

But regardless of how good your technique, the pattern between the first and last strip will rarely match up. For that reason, Gregoras always begins his job roomgood.ru behind a doorway, papering from the corner till he reaches the space above the doorway — at the least conspicuous place in the room.

Very often, the last strip of paper on a wall isn’t a full sheet. So another wallpapering suggestion Gregoras uses is to constantly paper the corners with broken sheets.

Click button on top right to expand illustration.

Apply Wallpaper Paste

Paint the whole room with a wall primer/sizer.

Unroll the wallpaper. As you do, check for defects and drag the paper from the border of your worktable to take away the curl.

Cut the paper into sheets 4 inches more than the height of your walls. Cut in precisely the same place on the replicate so patterns on adjacent sheets will line up.

Lay a cut sheet on the table, face down. Using a paint roller, apply a thin film of clear premixed wallpaper paste on the back of the paper.

Tip: Do not allow paste to get on the desk or it will mar the next sheet (wash it off with a barely damp sponge if it will ). Slide the paper all the way to the border of this table to use paste to the ends and edges.

Novel the Paper

Twist the pasted back of this paper onto it, top and bottom ends assembly in the middle. Guarantee that the side borders line up perfectly. Smooth the paper on itself as far as you can without creasing the folds.

Place the paper apart to permit the glue to soak in and the paper to relax. Be sure to follow the precise booking time recommended on the wallpaper’s tag, which differs based on its content (more for vinyl-coated wallcoverings, less for uncoated papers).

Align First Strip

Start in a corner near your door. In case the doorway is far from the corner, draw a reference line parallel to the door near the corner.

Unfold the top of the reserved paper and hang it on the wall. Overlap roughly 2 inches at the ceiling and 1/8 inch at the corner. Lightly press it in position.

Unfold the bottom of the book and let it hang. Examine the measurement between the paper and the door casing or reference line. Adjust the paper to keep it parallel to the door but nevertheless overlapping at ⅛ inch at the corner.

Tuck and Trim the Paper

(Don’t press so hard that you push out glue.)

Trim the excess paper at the ceilingPush a 6-inch taping knife to the joint between the ceiling and wall. Using a razor, cut over the knife to cut the surplus. Work gradually. Alternate between moving and cutting the knife. Do not slide the razor and knife together. Continue papering to some point above the door.

Continue Papering

On the adjoining wall, then draw a plumb line (if there’s no door or door ).

Hang a strip in the corner. Overlap the present piece on the adjacent wall by 1/8 inch. Measure to the plumb line and adjust the paper to keep the space equivalent. Smooth the paper. Lean in the ceiling and cut on the corner.

Hang another strip of paper. Unfold the top of the book and place it on the wall. Match the pattern as closely as you can, leaving just a hair’s breadth between the sheets.

Tip: Push out air bubbles by sweeping the newspaper simpler from the middle out to the edges. Wipe off paste on the surface using a sponge.

Close to the Seams

Lightly press on the top of the paper into the wall. Then lightly roll the seam using a seam roller to flatten down the borders.

Unfold the bottom of the sheet and complete fitting and closing the seam. Then tightly roll down the entire seam, working a full 3 inches from the border. This locks the seam, preventing it from opening as you smooth the newspaper.

Smooth the entire sheet. Continue papering the room, overlapping and trimming corners as shown in Step 5.

Suggestion: If the booked end of this strip begins to dry out until you hang it, wipe the wall with a damp sponge. This will remoisten the paste when you hang the paper.

Cut in Around Moldings

At doors and windows, let the paper float the molding by an inch.

Using the razor, make a relief cut in the paper. Carefully run the razor from the molding corner out to the border of the paper. Use the molding as a guide.

Press the cut edge tight in the joint between the molding and the wall.

Smooth down the whole sheet.

Tip: Mistakes are unavoidable when you’re learning how to hang wallpaper. Hide little cutting mistakes on darker papers by coloring the wall or the white edge of the paper with a marker that matches the newspaper. Some pros even color all the paper’s borders so seams aren’t as evident should the paper shrink as it dries.

Cover Alter

Paper the cover plates of electrical fixtures to make them vanish. Cut a sheet of wallpaper bigger than the plate. Cut out of the part of the pattern which matches the paper onto the wall round the switch.

Hold them on the wall and then adjust the paper to match the pattern on the wall.

Hold the paper and flip the plate . Cut off the corners 1/8 inch off from the plate. Wrap the paper above the plate and tape it on.

Cut out the change or receptacle holes with a razor. Make Xs at the screw holes. Screw the plates back on the wall.

LEAVE A COMMENT